THE LEGO MOVIE logo - small scale

[Noodlenut]

After seeing a post on The Brother's Brick, I got inspired and decided to create my own small scale THE LEGO MOVIE logo.

Because of my lack of pieces, I had to construct a cube and build the words over it.  I know that grey is not the ideal color, but that is what I had.  I still want to buy some pieces on Pick-A-Brick to finish off the texture on the front.

Here's the back:

Comments, criticisms, and suggestions welcome!

[glenbart]

The **** stuck to the E rather spoils it and the grey lego makes it look dusty. It looks nothing like the one on brothers brick, so close to being quite good though.

[glenbart]

If you look at the one on brother brick, "the" actually covers "lego" you need an 8 x 10 plate, im not sure lego do them so try a 6 x 10 and a 2 x 10... instead of the 8 x 8 "the" is on.

[glenbart]

I have a sack of black plates, I'd send you them for free but postage to the states cost too much.

[Noodlenut]

If you look at the one on brother brick, "the" actually covers "lego" you need an 8 x 10 plate, im not sure lego do them so try a 6 x 10 and a 2 x 10... instead of the 8 x 8 "the" is on.

Thanks for the suggestion.  I'll try that.

[Guest brickcrazyhouse]

Grey looks just fine great job

[Noodlenut]

After much contemplation on how to make "T" "****," and "E" "unstuck," I decided to put a 1X8 plate at the top followed by a 1X10 and a 4X10. After that, I put a 2X6 and a 2X2 to make a 2X8 at the bottom. If that did not make sense, here's the picture:

 

 

 

And here's a picture of the whole thing: